Parallax

Table of contents

1 Definition 2 Use in distance measurement 3 Informal introduction 4 Parallax of the human eye 5 Parallax and measurement instruments 6 Photogrammetric parallax 7 Lunar parallax 8 Solar parallax 9 Stellar parallax 10 Dynamic or moving-cluster parallax 11 The scale of the Universe 12 Parallax as a metaphor

Definition

Parallax is the change of angular position of two stationary points relative to each other as seen by an observer, due to the motion of said observer. Or more simply put, it is the apparent shift of an object against a background due to a change in observer position.

Use in distance measurement

Distance measurement by parallax is a special case of the principle of triangulation, where one can solve for all the sides and angles in a network of triangles if, in addition to all the angles in the network, the length of only one side has been measured. Thus, the careful measurement of the length of one baseline can fix the scale of a triangulation network covering the whole nation. In parallax, the triangle is extremely long and narrow, and by measuring both its shortest side and the small top angle (the other two being close to 90 degrees), the long sides (in practice equal) can be determined.

Informal introduction

The two points mentioned in the definition above will be at different distances from the observer. The visual effect of parallax is caused by the fact that light follows straight lines. When the observer views the nearer point, the line of his vision toward that point is at a given angle within the full arc of his vision. For example, let us say that the view straight ahead is zero degrees, and one point, nearer the observer, is at minus five degrees while a point which is farther away is at minus two degrees. The apparent angular distance between the points is a subjective three degrees to the viewer. If the viewer moves ten meters to his right, the angular direction to the nearer object, as it is on a shorter radius, will change more than the angular direction to the farther object. So, for instance, when the angular direction to the nearer object is at minus ten degrees, the father object may only have moved to minus three degrees. Now the subjective angular difference in position is seven degrees. The objects appear to have moved relative to each other.

It is because of this effect that, in a moving car, one can look at distant mountains and see them seem to move (retard) in position beneath a seemingly motionless moon. The moon is at such a distance that the subjective angular change in position (direction) relative to an earth-bound observer is extremely slight, even as many miles are covered. The mountains, much closer, exhibit a much greater apparent change in angular position.

Put differently and somewhat more generally, distant objects appear to move with the car. This can be explained as follows: looking out from a car perpendicular to its motion, all objects move backward relative to the car, and for nearby objects the speed of change in direction is what the observer considers the normal consequence of his own movement; however, for distant objects this backward change in absolute direction is slow and much less obvious than the forward change in direction relative to nearby objects. It seems as if distant objects move parallel to the car with the same speed or only a little slower.

Parallax of the human eye

With a nearby object in front of you, gaze at infinity. Cover one eye with your hand. Then move your hand to cover your other eye instead. The nearby object will seem to jump horizontally.

It is this effect that allows us -- and certain other animals such as cats -- to see depth. It is used in simple stereo viewing devices, such as the Viewmaster(TM) used to view stereoscopic scenery in the form of two images taken from adjacent locations. The Apollo astronauts on the Moon knew how to take such stereo pairs, clicking two frames of the same object in locations shifted slightly horizontally with respect to each other.

A way to allow a crowd of people simultaneously to view a stereoscopic scene, is to provide them with anaglyphic glasses. One glass is red, the other green, and the stereo scene is produced by the printing process in a corresponding fashion. It is generally believed that such scenes are of necessity monochrome -- red for the left image, green for the right --, but this is not quite true: working colour anaglyphic scenes have been produced.

Instructions for self-producing anaglypic glasses by copying colour onto an overhead projector sheet can be easily obtained. Better quality glasses can also be purchased inexpensively from many science shops or internet mail orders.

If an optical instrument -- telescope, microscope, theodolite -- is imprecisely focused, the cross-hairs will appear to move with respect to the object focused on if one moves one's head horizontally in front of the eyepiece. This is why it is important, especially when performing measurements, to carefully focus in order to 'eliminate the parallax', and to check by moving one's head.

Also in non-optical measurements, e.g., the thickness of a ruler can create parallax in fine measurements. One is always cautioned in science classes to "avoid parallax." By this it is meant that one should always take measurements with one's eye on a line directly perpendicular to the ruler, so that the thickness of the ruler does not create error in positioning for fine measurements. A similar error can occur when reading the position of a pointer against a scale in an instrument such as a galvanometer. To help the user to avoid this problem, the scale is sometimes printed above a narrow strip of mirror, and the user positions his eye so that the pointer obscures its own reflection. This guarantees that the user's line of sight is perpendicular to the mirror and therefore to the scale.

In photography, one also talks about the parallax of a camera viewfinder: for nearby objects, a viewfinder mounted on top of the camera will show something different from what the lens 'sees', and people's heads may be cut off. The problem does not exist for the single lens reflex camera, where the viewfinder looks (with the aid of a movable mirror) through the same lens as is used for taking the photograph.

Example of lunar parallax: Occultation of Pleiades by the Moon

A primitive way to determine the lunar parallax from one location is by using a lunar eclipse. The full shadow of the Earth on the Moon has an apparent radius of curvature equal to the difference between the apparent radii of the Earth and the Sun as seen from the Moon. This radius can be seen to be equal to 0.75 degrees, from which (with the solar apparent radius 0.25 degrees) we get an Earth apparent radius of 1 degree. This yields for the Earth-Moon distance 60 Earth radii or 384.000 km.

Another way to use parallax to determine the distance to the moon would be to take two pictures of the moon at exactly the same time from two locations on earth, and compare the position of the moon relative to the visible stars. Using the orientation of the earth, and those two points, and a perpendicular displacement, a distance to the moon can be triangulated.

• distance_moon = distance_{observer base} / tan(angle)

After Johannes Kepler discovered his Third Law, it was possible to build a scale model of the whole solar system, but without the scale. To fix the scale, it suffices to measure one distance within the solar system, e.g., the mean distance from the Earth to the Sun or astronomical unit (AU). When done by triangulation, this is referred to as the solar parallax, the difference in position of the Sun as seen from the Earth's centre and a point one Earth radius away, i.e., the angle subtended at the Sun by the Earth mean radius. Knowing the solar parallax and the mean Earth radius allows one to calculate the AU, the first, small step on the long road of establishing the size -- and thus the minimum age -- of the visible Universe.

It was proposed by Edmund Halley in 1716, that the transit of Venus over the solar disc be used to derive the solar parallax. And so it was done in 1761 and 1769. There is the famous story of the French astronomer Guillaume Le Gentil, who travelled to India to observe the 1761 event, but didn't reach his destination in time due to war. He stayed on for the 1769 event, but then there were clouds blocking the Sun...

Stellar parallax

Stellar parallax motion

On an interstellar scale, parallax created by the different orbital positions of the Earth causes the stars to seem to move.

The annual parallax is defined as the difference in position of a star as seen from the Earth and Sun, i.e. the angle subtended at a star by the mean radius of the Earth's orbit around the Sun. Given two points on opposite ends of the orbit, the parallax is half the maximum parallactic shift evident from the star viewed from the two points. The parsec is the distance for which the annual parallax is 1 arcsecond. A parsec equals 3.26 light years.

The distance of an object (in parsecs) can be computed as the reciprocal of the parallax. For instance, the nearest star, Alpha Centauri, has a parallax of 0.750". Therefore the distance is 1/0.750=1.33 parsecs or about 4.3 light years.

; Computation :

• The parallax in arc seconds
  • astronomical unit = Average distance from sun to earth = 1.4959e11 meters

distance to the star

Picking a good unit of measure will cancel the constants.

Derivation:

• (right triangle)

(small angle approximation) arcseconds

parallax

If the parallax is 1", then the distance is 206264 au = 3.2616 lyr = 1 parsec (This defines the parsec)

The parallax arc seconds, when distance given in parsecs

Measurements of the annual parallax as the earth goes through its orbit was the first reliable way to determine the distances to the closest stars. This method was first used by Friedrich Wilhelm Bessel in 1838 when he measured the distance to 61 Cygni, and it remains the standard for calibrating other measurement methods (after the size of the orbit of the earth is measured by radar reflection on other planets). In 1989, a satellite called "Hipparcos" was launched with the main purpose of obtaining parallaxes and proper motions of nearby stars, increasing the reach of the method ten-fold.

Dynamic or moving-cluster parallax

The open stellar cluster 'Hyades' (Rain Stars) in Taurus extends over such a large part of the sky, 20 degrees, that the proper motions as derived from astrometry appear to converge with some precision to a perspective point north of Orion. Combining the observed apparent (angular) proper motion in seconds of arc with the also observed true (absolute) receding motion as witnessed by the Doppler redshift of the stellar spectral lines, allows us to estimate the distance of the cluster and its member stars in much the same way as using annual parallax.

Dynamic parallax has sometimes also been used to determine the distance to a supernova, when the optical wave front of the outburst was seen to propagate through the surrounding dust clouds at an apparent angular velocity, when we know its true propagation velocity to be that of light.

The scale of the Universe

All these various astronomical parallax methods allow us to establish the first rungs on the cosmic scale ladder, out to a few hundred light years. Beyond that, other methods must be taken into use: e.g., "spectroscopic parallaxes" -- not really parallaxes at all. It is a prototype of a "standard candle" method, where we observe the apparent brightness of an object we know, based on some physical theory, the true brightness of. For groups of stars we have the Hertzsprung-Russell diagram which allows us to derive a star's absolute brightness or magnitude from its spectral type. The observed (apparent) brightness or magnitude being , we can then derive its parallax by

Further methods, mostly of the "standard candle" variety, are the variable stars called Cepheids -- the absolute brightness of which depends on their observed period of variation --, supernova brightnesses, spherical cluster sizes and brightnesses, complete galaxy brightnesses etc. These are all much more uncertain as they are not based on simple geometry. Yet, parallaxes are the basis of everything, as they allow the calibration of these more uncertain methods in the Solar neighbourhood.

Parallax as a metaphor

In a philosophic/geometric sense: An apparent change in the direction of an object, caused by a change in observational position that provides a new line of sight. The apparent displacement, or difference of position, of an object, as seen from two different stations, or points of view.